Ricoh AP-P2 G188 Field Service Manual page 239

2. Disconnect the printer from the network.
3. Remove the slot cover from the slot 2 ( x 1).
• Do not use the slot 1. The slot 1 is for customer use.
4. Turn the SD card face to the rear side of the printer, and insert it into the slot 2.
5. Slowly push the SD card into the slot until it clicks.
6. Make sure that the SD card is locked in place.
• To remove the SD card, push it in until it clicks, and release it slowly. The slot pushes out the SD
card.
7. Turn on the main power switch.
8. Wait until a firmware name is shown on the display (about 1 minute).
• The firmware name is read from inside the firmware. The firmware name is not changed even if
you change the file name on your PC.
9. If the necessary firmware name is shown on the display, check the firmware version with the left-arrow
or right-arrow keys. Pressing the left or right-arrow key shows a firmware name, firmware version and
serial number in order.
10. To use a different firmware, push the up-arrow key or the down-arrow key to find the necessary
firmware.
• Controller, engine and operation panel firmware cannot be updated at the same time. It is
recommended to update firmware modules one by one.
11. To select the firmware, push the OK key. Make sure that the selected firmware is high-lighted.
12. If you update more than one firmware program at the same time, find each of them and select each
of them. Make sure that the selected firmware is high-lighted.
• If the customer has used all of three slots, you have to keep an empty slot for this procedure. Ask
the customer to temporarily remove the SD card in the slot 2.
13. To start firmware update, push the "UpDate" key. While each firmware is downloaded, the
underscores on the operation panel are replaced by stars.
14. Wait until the message "Update done" is shown.
15. Turn off the main power switch.
16. Remove the SD card from the slot 2.
17. Attach the slot cover to the SD card slot 2 ( x 1).
Firmware Update
5
237