Table of Contents
Advertisement
10
Installation of Shower Fitting
A. Mira Virtue
1. Temporarily fit the rigid riser pipe and wall bracket to the shower control outlet
and mark the position of the wall bracket. Use a spirit level to ensure the pipe
is vertical. Drill the holes and insert the wall plugs.
Note! The vertical rigid riser pipe can be shortened if required. De-burr the pipe
ends before making the final connection.
2. Fix the wall bracket, rigid riser pipe, horizontal arm and tighten the three
compression fittings on the shower control outlet and horizontal arm.
Note! Care must be taken when tightening compression nuts so that you do
not damage the plated surfaces.
3. Turn on the hot and cold water supplies and check for leaks.
4. Thoroughly flush the outlet pipework before connecting the shower head. Slide
the compression nut and olive over the horizontal arm and make the connection
to the shower head.
Note! If fitting the flow regulator, make sure that it is fitted at this stage.
5.
Before using the shower, refer to section: 'Commissioning'.
Flow Regulator
Adapter
Horizontal
Arm
Showerhead
15
Wall Bracket
Rigid Riser
Pipe
1350004-W2-A
Advertisement
Table of Contents
