Table of Contents
Advertisement
6.
Decide on a suitable position for the Mixer. The position of the Mixer and
the Shower Fittings must provide a minimum gap of 25 mm between the
spill-over level of the shower tray/bath and the showerhead (refer to illustration).
This is to prevent back-siphonage. For further information on the installation
of your Shower Fittings, refer to the Fittings Installation and User Guide.
Note! Only use Shower Fittings recommended by the manufacturer or supplier.
Flow Regulator Installation
Flow regulators are supplied with this product and should be fitted in High Pressure
systems to either;
1.
Reduce Excessive Force and Flow Rate
2.
Reduce Noise through the mixer due to high or unequal pressures
3.
Stabilise incoming supply temperatures
1353004-W2-A
Hose Retaining Ring
10
25 mm Spill
Over Level
Advertisement
Table of Contents
