Alcatel Temporis IP150 Administration And Provisioning Manual page 64

3. Press  and enter the Subnet Mask. Use BACKSP softkey, digit dial pad and "*" key to
enter characters and dots.
4. Press  and enter the Gateway. Use BACKSP softkey, digit dial pad and "*" key to
enter characters and dots.
5. Press SAVE softkey.
To set the VLAN ID for the base or desktop phone:
1. From the Network setting menu, press  or  to highlight VLAN ID, and then press
OK.
2. On the VLAN ID menu, press OK to toggle between Enable and Disable states for WAN
VLAN.
3. Press  and enter the WAN VID. Use the dial pad and the
characters. The valid range is 0 to 4095.
4. Press  and enter WAN Priority. Use the dial pad and the
characters.
5. Press SAVE.
To set other settings (DNS and NTP):
1. From the Network setting menu, press  or  to highlight Others, then press OK.
If DHCP is disabled, the Others menu appears. If DHCP is enabled, an error message
appears briefly before returning you to the Network setting menu.
2. Enter the IP address for the primary DNS server. Use BACKSP softkey, digit dial pad
and "*" key to enter characters and dots.
3. Press  and enter the IP address for the secondary DNS server. The phone uses this
server if the primary server does not respond. Use BACKSP softkey, digit dial pad and
"*" key to enter characters and dots.
Business IP Range Administration and Provisioning Guide
BACKSP soft key to enter
BACKSP soft key to enter
ed 2.2 64/247