Alcatel Temporis IP150 Administration And Provisioning Manual page 29

NOTE: You may need to use a network switch connected to your router if your router
does not have sufficient ports for the number of phones you want to install. If you use a
network switch, connect the phone to the switch instead of the router in the previous
3. If the deskset is not using power from a PoE-capable network router or switch, or in any
case for an IP150M:
a. Connect the power adapter to the deskset power jack.
b. Plug the power adapter into an electrical outlet not controlled by a wall
switch.
IMPORTANT INFORMATION
1. Use only original power adapters. Contact your distributor to order.
2. The power adapter is intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
If there is a networked computer and no extra Ethernet wall ports near the phone, then the
phone and PC can share the same network connection.
To share a network connection with a PC (IP150/IP151 only):
1. Plug a Cat.-5 Ethernet cable into the PC port on the phone.
2. Plug the other end of the Cat.-5 Ethernet cable into your computer's network port.
If a GigE network is being used, a computer connected through the phone will be limited to
100 Mbits/s. If you require a GigE Ethernet rate, use separate Ethernet connections for the
phone and the computer.
If a PC is connected to your network through a phone, any phone resets and power or
network interruptions will disrupt the PC's connection to the network.
Business IP Range Administration and Provisioning Guide
step.
ed 2.2 29/247