Mazda CX-5 Manual page 709

WARNING
Never operate the compressor above
300 kPa (3.1 kgf/cm
Operating the compressor above 300
kPa (3.1 kgf/cm
dangerous. When the inflation pressure
rises above 300 kPa (3.1 kgf/cm
43.5 psi), heated air will be exhausted
from the back of the compressor and
you could be burned.
NOTE
Check the tyre inflation pressure

label (driver's door frame) for the
correct tyre inflation pressure.
Do not use the compressor for

longer than 10 minutes because
using the compressor for long
periods could damage it.
If the tyre does not inflate, repair of

the tyre may not be possible. If the
tyre does not reach the correct
inflation pressure within a 10-minute
period, it probably has received
more extensive damage. When this
happens, the emergency flat tyre
repair kit cannot be used to repair
the tyre. Contact an expert repairer,
we recommend an Authorised Mazda
Repairer.
If the tyre has been over-inflated,

loosen the screw cap on the
compressor and bleed some of the
air out.
16. When the tyre has been inflated to the
proper inflation pressure, turn the
compressor switch off and remove the
compressor hose from the tyre valve.
17. Install the tyre valve cap.
2
, 3 bar, 43.5 psi):
2
, 3 bar, 43.5 psi) is
2
, 3 bar,
18. Put the emergency flat tyre repair kit in
the boot and continue driving.
CAUTION
Drive carefully to an expert repairer,
we recommend an Authorised
Mazda Repairer and keep the vehicle
speed below 80 km/h (50 mph).
If the vehicle is driven 80 km/h (50
mph) or higher, the vehicle might
begin to vibrate.
NOTE
(With Tyre Pressure Monitoring
System)
If the tyre is not properly inflated, the
tyre pressure monitoring system
warning light will illuminate (page
7-45).
19. After driving the vehicle for 10
minutes or 5 km (3 miles), check the
tyre pressure with the tyre pressure
gauge equipped with the compressor. If
the tyre pressure has fallen below the
correct tyre pressure, inflate the tyre to
the correct pressure again following
the steps from number 14.
CAUTION
If the tyre inflation pressure falls
below 130 kPa (1.3 kgf/cm
18.9 psi), repair cannot be done with
the repair kit. Park the vehicle on a
level surface off the right-of-way and
contact an expert repairer, we
recommend an Authorised Mazda
Repairer.
If Trouble Arises
Flat Tyre
2
or bar,
7-23