Siemens SINAMICS S120 Equipment Manual page 97

Cable routing of signal cables to the customer terminal block -X55
1. Feed the cable for the customer terminal block into the cabinet from the bottom left.
2. Use cable ties to secure the cable at suitable points.
3. Guide the cable further up into the cabinet and, when it reaches customer terminal block
4. Use cable ties to secure the cable at suitable points.
5. Connect the cables to the customer terminal block -X55.
Cable routing for the "Safe Torque Off" and "Safe Stop 1" functions
Note
The procedure is the same as that for the customer terminal block.
Connect the cable to the terminals that carry out the functions.
(→ See the chapter titled "Options", section "K82, terminal module for activating "Safe Torque
Off" and "Safe Stop 1"")
S120 Cabinet Modules Equipment Manual
Manual, (GH5), 10/2008, A5E00427098A
Frame size:
FX+GX HX+JX
-X55, guide it to the left or right to -X55. When doing so, route the cable in a similar
manner to the standard cables that have already been installed in the cabinet.
Electrical installation
4.5 Connections
97