Fisher & Paykel OR90 Series Installation Manual page 16

Dual fuel freestanding cooker
Hide thumbs Also See for OR90 Series:
Table of Contents

Advertisement

IMPORTANT!
The connection must be performed by an authorised person
according to the relevant standards.
The gas supply must use the gas inlet pipe which is located
at the left hand side at the rear of the appliance.
Before connecting the appliance to the gas main,
1
fit the female connector to the left inlet pipe using
the fibre washer supplied. Ensure connector is
positioned as shown above.
Gas inlet pipe
Connector
17
!7
GAS CONNECTION
IMPORTANT!
Use two wrenches to tighten the connection.
Tighten the connection between the inlet pipe and
2
connector. Once tightened, fit the hose to the connector.
Ensure the hose is not crushed, trapped or in contact
with sharp or abrassive edges or subjected to corrosion
by acidic cleaning agents. The hose should also be
connected in such a way that it does not touch the floor
and must hang in a natural loop between the appliance
and the bayonet fitting..
A restraining chain (not supplied) must be
3
attached securely to the cooker and the rear
wall. This is used to prevent stress being applied
to the gas hose or pipework.
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Or90scg4Or90sdg4Or90scg6Or90sdg6

Table of Contents