Hybrid Cable Connection - Siemens LDS 6 Operating Instructions Manual
In-situ laser continuous gas analyzer
Hide thumbs
Also See for LDS 6:
- Operating instructions manual (84 pages) ,
- Compact operating instructions (70 pages) ,
- Product information (30 pages)
Table of Contents
Advertisement
3.3.2
Hybrid Cable Connection
The hybrid cable is connected at the back of the central unit, where its two optical cables and
the supply line for the sensor wire are attached, as shown in the picture below.
Figure 3-1
Keep the fiber end protected, by the protective tube, until it is time for connection. Only
authorized personnel are entitled to remove the protective tube and proceed with the
connecting operation.
1. Hybrid cable holder.
2. E2000 Single Mode fiber connector, angle polished.
3. SMA Multi Mode fiber connector.
4. Sensor voltage supply connection. 24 V/60 mA.
5. Signal output connections.
6. Network connection. Ethernet 10Base-T (RJ-45).
See also
Pin Assignment of LDS 6 (Page 34)
Signal Cable Connection (Page 32)
LDS 6
Operating Instructions, 01/2009, A5E00295894-05
1
LDS 6 cable connections (here only channel 3 is connected)
WARNING
2
Installation Guidelines
3.3 Electrical Connections
3
4
5
6
31
Hide quick links:
Advertisement
Table of Contents
