[B] Storage Bin And Scoop; [C] Air Filter; [D] Condenser; Preparing The Icemaker For Long Storage - Hoshizaki KM-40B Service Manual

[b] STORAGE BIN AND SCOOP

* Wash your hands before removing ice. Use the plastic scoop provided (Accessory).
* The Storage Bin is for ice use only. Do not store anything else in the bin.
* Keep the scoop clean. Clean it by using a neutral cleaner and rinse thoroughly.
* Clean the bin liner by using a neutral cleaner. Rinse thoroughly after cleaning.

[c] AIR FILTER

The plastic mesh Air Filter removes dirt or dust from the air, and keeps the Condenser
from getting clogged. As the filter gets clogged, the icemaker's performance will be
reduced. Check the filter at least twice a month. When it is clogged, use warm water
and a neutral cleaner to wash the filter.

[d] CONDENSER

Check the Condenser once a year, and clean if required by using a brush or vacuum
cleaner. More frequent cleaning may be required depending on the location of the
icemaker.

3. PREPARING THE ICEMAKER FOR LONG STORAGE

When shutting off the icemaker for an extended time, drain out all water
from the water lines and remove the ice from the Storage Bin. The Storage
Bin should be cleaned and dried. Drain the icemaker using air or carbon
dioxide to prevent damage to the water supply lines at sub-freezing
temperatures. Shut off the icemaker until the proper ambient temperature is
resumed.
When the icemaker is not used for two or three days, it is sufficient to only move
the Control Switch to the "OFF" position, unless the icemaker will be at sub-freezing
temperatures.
IMPORTANT
74