[B] Sanitizing Procedure; Maintenance; [A] Exterior Panels - Hoshizaki KM-40B Service Manual

[b] SANITIZING PROCEDURE - Following Cleaning Procedure
1) Dilute approximately 9.2 ml of an 8.25% sodium hypochlorite solution (chlorine
bleach) with 3.8 lit. of warm water. Using a chlorine test strip or other method,
confirm that you have a concentration of about 200 ppm.
2) Soak the removed parts from step 16 above in a clean container containing the
sanitizing solution. After allowing the parts to soak for 10 minutes, wash them with
the solution. Also wash the bin liner and brackets (L) and (R) with the solution.
3) Discard the sanitizing solution and rinse the parts thoroughly with water.
4) Replace the removed parts in their correct positions in the reverse order of which
they were removed.
5) Dilute approximately 9.2 ml of an 8.25% sodium hypochlorite solution (chlorine
bleach) with 3.8 lit. of warm water. Using a chlorine test strip or other method,
confirm that you have a concentration of about 200 ppm.
6) Pour the sanitizing solution into the water tank, and allow the sanitizer to sit for 10
minutes.
7) Move the control switch to the "WASH" position. Close the door.
8) After 15 minutes, move the control switch to the "OFF" position. Open the door.
9) Disconnect the silicone hose to drain the water. Reconnect the silicone hose back in
its correct position after all of the water has drained.
10) Repeat steps 5 through 9 one time. Repeat steps 8 through 11 in the Cleaning
Procedure three times to rinse thoroughly.
11) Flush the ice storage bin with water.
12) Move the control switch to the "ICE" position to start the automatic icemaking
process.
13) Close the door. Replace the air filter in its correct position.

2. MAINTENANCE

[a] EXTERIOR PANELS

To prevent corrosion, wipe the exterior occasionally with a clean and soft cloth. Use a
damp cloth containing a neutral cleaner to wipe off all oil or dirt build up.
73