3) Pinch and push down the Snaps on
both sides of the Bracket to unhook
the Water Tank from the square holes,
and pull it about 1" toward you.
4) When the Snaps are unhooked from
the square holes, the rear part of the
Water Tank (dotted circle below) is also
unhooked. Hold the Water Tank with
both hands.
5) Tilt the right side of the Water Tank and
pull it toward you. Do not hit the Pump
Motor or Float Switch. Slightly twist the
left side of the Water Tank inward and
pull it toward you.
Snap
Water Tank
Left Side
66
Fig. 22
Pump Motor
Float Switch
Fig. 23
Right Side
Fig. 24