Audio Settings - Bosch VIP X1600 Installation And Operating Manual

VIP X1600 | Installation and Operating Manual

Audio settings

You can set the gain of the audio signals to suit your specific requirements.
The associated video image is shown in the small window next to the slide con-
trols to help you check the audio source and improve assignments.
Your changes are effective immediately.
Note
The numbering of the audio inputs follows the labeling on the unit and the
assignment to the respective video inputs. The assignment cannot be
changed.
Enable audio:
The audio signals are sent in a separate data stream parallel to the video data,
and so increase the network load. The audio data are encoded according to
G.711 and require an additional bandwidth of approx. 80 kBit/s per direction for
each connection. Select On if you wish to enable the audio function.
Line In 1: to Line In 4:
You can set the gain of the audio signal. The current level is displayed next to
the slide control to help you do this. Make sure that the display does not go
beyond the green zone during modulation.
Selection
Click one of the option boxes to enable the required audio input.
Bosch Security Systems | 2006-03 | V2.0
EN | 47
Configuration using a Web Browser