Table of Contents
Advertisement
VIP X1600 M4S
–
–
5.7
Basic Mode: Audio (Audio Version Only)
You can set the gain of the audio signals to suit your specific requirements. The current video
image is shown in the small window next to the slide controls to help you check the audio
source and improve assignments. Your changes are effective immediately.
If you connect via Web browser, you must activate the audio transmission on the LIVEPAGE
Functions page (see Section 5.15 Advanced Mode: LIVEPAGE Functions, page 40). For other
connections, the transmission depends on the audio settings of the respective system.
Audio
The audio signals are sent in a separate data stream parallel to the video data, and so increase
the network load. The audio data are encoded according to G.711 and require an additional
bandwidth of approx. 80 kbps for each connection. If you do not want any audio data to be
transmitted, select Off.
Line In 1 to Line In 4
You can set the gain for the line inputs. Make sure that the display does not go beyond the
green zone during modulation.
5.8
Basic Mode: Recording
You can record the images from the camera connected to the module on an appropriately
configured iSCSI system.
You can start or stop the recording immediately here.
Storage medium
1.
2.
Bosch Security Systems
Modem
For analog modem connections with 20 kbps, resolution 352 × 288/240 pixels
GSM
For GSM connections at 9,600 baud, resolution 176 × 144/120 pixels
Select the required storage medium from the list.
Click the Start button to start the recording immediately.
Installation and Operating Manual
Configuration Using a Web Browser | en
DOC | V4.0 | 2009.06
31
Advertisement
Table of Contents
