Programming The Remote Controls To The Control Panel - CAME FROG series Installation Instructions Manual

3.5 - Programming the Remote Controls
To use the remote control system, proceed as follows:
A) Turn power OFF and insert AF radio frequency board then turn
power back on
B) Code the transmitter. See the relevant instruction sheet
(See Fig 11)
C) To store the code on the circuit board Proceed as follows:
Press and hold down the YellowCH1 button on the radio receiver
card (the signal LED will start to flash)
At the same time transmit on the top button of your remote
control; keep both the top button and the yellow receiver button
pressed until the LED stops flashing and remains on constant to
indicate that the code has been successfully stored.
N.B. If you wish to change the code on your transmitter in the future,
simply repeat the procedure above with all the remotes on the
installation.
WARNING:
to the Control Panel
Disconnect the power supply from the control board before
inserting OR removing the AF radio-frquency card from the
socket.
17