Pic Test Section 6; Pic Test Section 7; Pic Test Section 8 - HP MICRO 3000 Diagnostic Manual

Error Codes
PIC Test Section 5
This section tests PiC registers 4 and 5 by reading and writing data. Functions are not tested.
Code Error
0501 Register 4 fails to show data patterns SOOe.
0502 Register 5 fails to show data patterns SOOAA.
0503 Register 4 fails to show data patterns S0055.
0504 Register 5 fails to show data patterns S0055.
PIC Test Section 6
This section tests PIC register 6 (IIP-18 control register).
Code Error
0601 Register
6
fails to show patterns $802A for read/write test.
0602 Register 6 fails to show patterns $4054 for read/write test.
0603 Bits 12 and 14 of the liP-In controller chip interrupt
register (PIC register 2) should be set (outbound FIFO NOT
full and idle.
0604 Bits 12 and 14 of the liP-In controller chip interrupt
register (PIC register
2)
should be clear (outbound
1-"1£70
NOT full and idle.
0605 Bit 15 of register 6 should be set (clear out bound
FI£70)
via
the liP-Ill controller chip interrupt register test. Bits 12
and 14 of the uP-In controller chip interrupt register
should be clear.
PIC Test Section 7
This section tests PIC register
7
{IIP-IB address).
Code Error
0701
Regisier 7 fails io show patterns $ SOGA for read/write test.
0702 Register
7
fails to show patterns $4015 for read/write test.
0703
Bit 9 of Register 7 should be set (talk always) via the liP-In
controller chip status register (PIC register
I)
test.
Bits 13 or 14 of the IIP-IB controller chip register should
be
off to indicate NOT a laik
or
a
iisten.
0704 Bit 10 of register 7 should be set (listen always) via the
DEC 86
111)-11\ controller 'hip status register test. Bit 13 of the
HP-IB controller chip status register must be on to indicate
a talk always.