Connecting Ciper Model 50 Via Its Rs485-1 Interface To A Panel Bus - Honeywell CIPer 50 Installation & Commissioning Instructions

CIPer MODEL 50 CONTROLLER – INSTALLATION & COMMISSIONING INSTRUCTIONS

Connecting CIPer Model 50 via its RS485-1 Interface to a Panel Bus

NOTE: When connecting an CIPer Model 50 via its RS485-1 to a Panel Bus I/, it is recommended that the slide switch be
set to "END."
Fig. 34. Connecting an CIPer Model 50 controller via its RS485-1 interface to a Panel Bus (single transformer)
Fig. 35. Connecting an CIPer Model 50 controller via its RS485-1 interface to a Panel Bus (two transformers)
31-00233EFS-01 28