Honeywell CIPer 50 Installation & Commissioning Instructions page 12

CIPer MODEL 50 CONTROLLER – INSTALLATION & COMMISSIONING INSTRUCTIONS
2. To login and change the IP address and/ or configure
further network settings, press 1.
RESULT: You will be asked to enter your username.
3. Enter the user name and press Enter.
RESULT: You will be asked to enter your password.
4. Enter the password and press Enter.
RESULT: The Main menu displays.
5. Press 1 in the Main menu.
RESULT: The Network Setup displays.
31-00233EFS-01
6. Configure the network as desired by applying the
available options displayed.
7. To reset the controller to factory defaults, press F in the
Boot menu.
ATTENTION: Resetting the controller to its factory
defaults will result in the following:
• The station will be deleted.
• The platform credentials will be deleted.
• The IP settings will be reset to the factory defaults (see
section "Default IP Addresses of Ethernet Interfaces 1
and 2" on pg. 8).
RECOMMENDATION: Before leaving (closing) the
8. Reset the controller by entering Y.
12
terminal program, go to "Network
Setup" and enter the desired IP
settings.