Connecting Ciper Model 50 Via Its Rs485-1 Interface To A Panel Bus - Honeywell CIPer 50 Installation & Commissioning Instructions

– Total max. no. of Panel Bus I/O modules: 128
• Max. no. of hardware I/O points per CIPer Model 50: 1000 (given a polling rate of 2 seconds)

Connecting CIPer Model 50 via its RS485-1 Interface to a Panel Bus

NOTE
When connecting an CIPer Model 50 via its RS485-1 to a Panel Bus I/, it is recommended that the
slide switch be set to "END."
Figure 35: Connecting an CIPer Model 50 controller via its RS485-1 interface to a Panel Bus (single
Figure 36: Connecting an CIPer Model 50 controller via its RS485-1 interface to a Panel Bus (two
CIPer MODEL 50 CONTROLLER – INSTALLATION AND COMMISSIONING INSTRUCTIONS
TM
transformer)
transformers)
47 31-00233-02