Controlling The Projector Through A Lan Environment (Mp526/Mp576 Only) - BenQ MP515 User Manual

Controlling the projector through a Lan
environment (MP526/MP576 only)
Lan Control Settings allow you to manage the projector from a computer using a web
browser when the computer and the projector are properly connected to the same local
area network.
Configuring the Lan Control Settings
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector
and the other end to the RJ45 port.
2. Press Menu/Exit and then press
is highlighted.
3. Press
Settings page displays.
4. Press
5. Press
6. Press
7. Please wait for around 15 - 20 seconds, and then re-enter the Lan Control Settings
page.
8. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings
will be displayed. Note down the IP address displayed in the Projector IP Address
row.
If the Projector IP Address still does not display, contact your ITS administrator.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press
3. Contact your ITS administrator for information on the Projector IP Address,
Subnet Mask, Default Gateway, and DNS Server settings.
4. Press
5. Press
6. To save the setting, press Mode/Enter. If you do not want to save the setting, press
Menu/Exit.
7. Press
42 Operation
to highlight Lan Control Settings and press Mode/Enter. The Lan Control
to highlight Control By and press
to highlight DHCP and press
to highlight Apply and press Mode/Enter.
to highlight DHCP and press
to select the item you want to modify and press Mode/Enter.
/ to move the cursor and then press
to highlight Apply and press Mode/Enter.
/ until the SYSTEM SETUP: Advanced menu
/ to select RJ45.
/ to select On.
/ to select Off.
/ to enter the value.