Switching Input Signal - BenQ MP515 User Manual

Switching input signal

The projector can be connected to multiple devices at the same time. However, it can
only display one full screen at a time. When starting up, the projector automatically
searches for the available signals.
Be sure the Quick Auto Search function in the SOURCE menu is On (which is the
default of this projector) if you want the projector to automatically search for the
signals.
You can also manually cycle through the available input
signals.
1. Press SOURCE on the projector or remote
control. A source selection bar displays.
2. Press
and press Mode/Enter.
Once detected, the selected source information
will display at the corner of the screen for seconds.
If there is multiple equipment connected to the
projector, repeat steps 1-2 to search for another
signal.
• The brightness level of the projected image will change
accordingly when you switch between different input
signals. Data (graphic) "PC" presentations using
mostly static images are generally brighter than
"Video" using mostly moving images (movies).
• The native display resolution of this projector is in a 4:3 aspect ratio. For best display
picture results, you should select and use an input signal which outputs at this resolution.
Any other resolutions will be scaled by the projector depending upon the "aspect ratio"
setting, which may cause some image distortion or loss of picture clarity. See
the aspect ratio" on page 31
30 Operation
/ until your desired signal is selected
for details.
(MP515)
"Selecting