Settings - Panasonic DMR-UBT1 Operating Instructions Manual

Settings

Before use, perform the initial setup of the unit.
Easy Setting
Preparation
Turn on the TV, then select the appropriate AV
input to suit the connections to this unit.
1
Press [Í] on the remote control or [Í/I] on
this unit.
2
Follow the on-screen instructions to continue
with the settings.
• For details about "PIN Entry" (
3
Auto Setup will start automatically.
• If the clock setting screen appears, set the
time manually (
• When connected to a 4K compatible TV
( right)
4
Set Quick Start to "On", "Off" or "Timer
Setting for Quick Start", then press [OK].
When "Easy Setting has been completed."
appears, Easy Setting is completed.
• Select "Yes" to proceed to Easy Network
Setting.
• Select "No" to finish the Easy Setting.
To restart setup ( 48, Auto Setup)
To view the list of tuned channels
( 11, Using Channel List)
To stop partway
Press [RETURN ].
• If tuning is cancelled partway through, it may not be
possible to receive the channels. Restart setup again.
55)
55, Clock).
When connected to a 4K compatible TV
When connected to a 4K compatible TV,
connection setting to 4K TV below is displayed.
4K(50p/60p) Output
Start connection check with your 4K TV.
Once connection check is started and if the video is not displayed
correctly, please wait for the next display. The connection check
could take up to 30 seconds to display the new message screen.
Press OK.
OK
RETURN
The screen above does not appear for a non-4K
compatible TV.
1 Press [OK] to start the setting.
A black screen appears for a few seconds and
then a message appears.
4K(50p/60p) Output
Is this message displayed correctly ?
Yes
OK
RETURN
2 Select "Yes" and press [OK].
Connection to 4K TV is successful.
(Go to next step of "Easy Setting".)
When the following screen appears:
4K(50p/60p) Output
Connection check is finished.
Cannot connect with 4K.
Please check if the HDMI connected
device and cable are compatible with 4K.
Move on to the next setting ?
Select "Yes" for the next setting.
Select "No" to set again.
Yes
OK
RETURN
"Yes": Next setting is displayed.
"No": Connection setting to 4K TV starts again.
(Retry the setup process.)
• To reconnect this unit to a 4K-compatible TV after
connecting this unit to a 2K-compatible TV and completing
"Easy Setting", set "4K(50p/60p) Output" to "4K(50p/60p)
4:4:4" or "4K(50p/60p) 4:2:0". (
No
No
52)
9
TQBS0291