Alpine TDA-7567R Owner's Manual page 98

Remote Control/Télécommande/
Controlador remoto
RUE-4180
1
2
3
98
1
(Supplied with TDA-7567R)
(Fournie avec le TDA-7567R)
(Suministrado con el TDA-7567R)
SOURCE
A. S. U.
SOURCE
BAND
PROG
CHGR-X
BAND
PROG
CD Shuttle Operation
Multi-Changer Selection
Alpine's Ai-NET system will support up to 6 CD
Shuttles. When operating two or more
changers, the KCA-400C (Multi-Changer
Switching device) must be used. If you use 1
Switching device, you can connect up to 4 CD
Shuttles. If you use 2 Switching devices, you
can connect up to 6 CD Shuttles.
Press the SOURCE button on the TDA-7567R/
TDA-7565R to activate the CD Shuttle mode.
Alternatively, press the SOURCE button on the
Remote Controller (RUE-4180) to activate the
CD Shuttle mode. Proceed to Step 3 below to
select the desired CD Shuttle.
Press the BAND button on the TDA-7567R/
TDA-7565R to activate the CD Shuttle Selec-
tion mode.
The CD Shuttle Selection mode remains active
for 3 seconds after Step 2 is performed. Press
the BAND button until the desired CD Shuttle
indicator appears on the display.
Note: If the selected CD Shuttle is not con-
nected, the display will show "NO CHGR-
X."
English