Digital Temperature Controller Setup - Omron E5*D Series Connection Manual

7.2.

Digital Temperature Controller Setup

Set up the Digital Temperature Controller.
7.2.1. Parameter Settings
Set parameters for the Digital Temperature Controller.
1
Connect the power supply and a
serial cable to the terminal block
located on the back of Digital
Temperature Controller.
*Only the parameters in
Communications Setting Level
are described in this guide.
If you use the parameters in
Adjustment Level that is
specific to each of the models,
refer to their respective
manuals.
2
Check the positions of each of
the keys, No.1 and No. 2
displays and Operation
indicators.
In this guide, the keys are
described as follows:
L (Level) Key
M (Mode) Key
U (Up) Key
D (Down) Key
3
Turn ON Digital Temperature
Controller.
4
The current temperature is
displayed on No. 1 display once
Digital Temperature Controller is
turned ON. (Operation Level)
Press the L (Level) Key for at
least 3 seconds.
7．Serial Communications Connection Procedure
Serial cable
(RS-485)
L (Level) Key for at least 3 seconds
11