Raytheon NSC 18 User Manual page 74

Left
Press button
to save the value
D Position sensor selection to select the source sensor to obtain your own
Left
3748DOC020102
Operator Manual
AUTO mode
Set and drift information is derived from the speed sensor input.
If the speed source is lost due to malfunction, the values will be canceled.
Select another speed sensor if possible or switch to manual or select
Reference Target.
MANUAL mode
Place the cursor on the toggle field and press and hold the Left button on
the trackball. To set MANUAL inputs, use the slider function and the trackball.
Release the Left button and press it again.
The parameter values for SET and DRIFT depend on one another.
Both parameters must therefore be defined separately but as a pair.
The NSC system will not accept a single parameter value as an input
value.
ship's position data in latitude and longitude.
If a position sensor is to be selected as the source input, then place
the cursor on the toggle field and press the trackball button.
The POSITION SENSOR SELECTION function display appears.
Select a sensor.
2−56
Edition: 14.JAN.2005