Switching Off The Nsc Radar System - Raytheon NSC 18 User Manual

2.2.6

Switching OFF the NSC radar system

The following procedure should be used to switch off the NSC radar system.
Procedure:
Switching the radar OFF
Tx
Using the trackball, place the cursor on the TX softkey and press the
Left
button from the trackball group.
The name of the softkey changes to STBY and is highlighted.
STBY
EXIT
Pressing this softkey the RADAR Utility selector appears
RADAR
Select Operator Close System and Power Off in the RADAR Utility selector
Left
window and press the button from the trackball again.
3748DOC020102
Operator Manual
− radar echo disappears
− the antenna stops, no transmission
− the name of the softkey FUNC changes to SERV (Service).
− the softkey EXIT RADAR appears
+++ RADAR Utility selector +++ +++ RADAR Utility selector +++
Utility Selections Utility Selections
Operator Change Date/Time Operator Change Date/Time
Operator Close System and Power Off Operator Close System and Power Off
Operator Refresh Radar Operator Refresh Radar
Service Switch to Admin + password Service Switch to Admin + password
Service Report Export to USB Service Report Export to USB
Service Raytheon Update from USB memory Service Raytheon Update from USB memory
Service Display Resolution Service Display Resolution
Service Display Network Service Display Network
Figure: 2−13 RADAR Utility selector
Run Selection Run Selection
RADAR RADAR
2−22
Edition: 14.JAN.2005