2.2.1
Switching ON
Positioned on front, lower left side.
Power button
Pressing the button switches on the power.
RADAR
3748DOC020102
Operator Manual
D The Radar Utility Selector window appears in the display.
Select the RADAR softkey in the window and press the Left
button on the trackball.
D After about 40 seconds, the message STANDBY appears in the image
center.
D The system configuration diagram is shown in the center of the display
area (see Figure: 2−7).
Select the desired transceiver combination XCVR ..... and the
master/slave assignment if possible (system specific).
The STANDBY message changes to WARM UP.
D After a few minutes the warm up period is
complete and the WARM UP message changes back to STANDBY.
D NSC Radar is in STANDBY mode.
The NSC beeps when
the NSC radar software detects an internal or external malfunction;
a simultaneous alarm message is displayed.
Acknowledging the alarm message switches off the acoustic signal. The
alarm message is hidden, but it can be called up again.
NSC status:
The transceiver is not transmitting.
The antenna is not rotating.
No radar video in PPI, STANDBY.
Service and setup menu accessible.
The operating temperature is maintained by the magnetron.
2−8
Edition: 14.JAN.2005