Procedure 2-2 - Nortel 6220 User Manual

56

Procedure 2-2

Mounting the CSU on the Steel Wire Strand
Action
Step
1. Loosen the EMI cap and slide the CAT5 or 6 cables without the RJ45
connector into the hole of the EMI hood shaped cap.
Follow the conventional procedure of creating a CAT5 or 6 Ethernet cable.
Note: It is recommended to use a shielded cable like S-FTP(Foiled Twisted
Pair) or STP (Shielded Twisted Pair) in which wire pairs are covered with
overall shield material to prevent EMI effects to or from the near electronic
devices or facilities.
Note: The cable from CSU to POE Injector and from POE Injector to CPE
(PC) should be a straight-through cable.
2. Connect a cable to the POE port on the front panel of CSU through the
hole of EMI cap and tighten it firmly.
Figure 3-6
Connecting Ethernet Cable to CSU and Securing the EMI Cap
Action
WLAN Cable Access Point 6220 NTPM99CA 01 Rel 1.0 Issue 3 Dec 2004