Table of Contents
Advertisement
66
Figure 4-9
Interface setup dialog box
16. If you have an 802.11 radio card, click the Setup 2 button to set up
the 802.11 interface.
17. Click the Setup 2 button. The IEEE 802.11 Setup screen is displayed,
as shown in Figure 4-10.
18. Select a radio standard to use according to the built-in antenna
specification like an operating frequency range.
Ex) 2.4GHz antenna : 802.11b/g, 5.8GHz antenna: 802.11a
19. Make sure the APU Secure Data Mode in the left portion of Mode
Selection is selected while "Polling Base station" is clicked in Secure
Data Mode Base Station Mode.
20. Select the Enable Signal Quality Front Panel Display checkbox if
your unit has a front panel display that is capable of displaying the
signal quality.
Figure 4-10
Interface setup dialog box
WLAN Cable Access Point 6220 CSU NTPM99CA Rel 2.0 Issue 5 Dec 2005
Advertisement
Table of Contents
