Procedure 2-1 - Nortel 6220 User Manual

54

Procedure 2-1

Mounting the CSU on the Steel Wire Strand
Action
Step
1. Prior to an installation, check if the Pole has the strength and stability to
sustain the weight of CSU in a strong wind
2. Please find a mounting tool for installing CSU illustrated in Figure 3-
30
3. Place the CSU face (RADOME side) down on a flat surface.
4. Using the mounting tool, attach the Mounting Tilt Brackets to the back
of CSU and insert the two stainless steel M6 hex head screws and M6
split lock washers into the hole.
Figure 3-3
Assembling the mounting bracket on the CSU
5. Lift the CSU to a selected installation point on the pole and then attach
the clamp to the original location while lashing the CSU to the pole or
using a hoisting rope to keep the unit in place during mounting work.
6. Slide two mounting nuts through a washer to each bracket hole as
illustrated in Figure 3-3
7. Adjust the azimuth of CSU Antenna RADOME toward the remote unit
and fasten sufficiently to secure the CSU on the pole.
Action
WLAN Cable Access Point 6220 NTPM99CA 01 Rel 1.0 Issue 3 Dec 2004