Nortel 6220 User Manual page 118

Enable Signal Quality Front Panel Display-- On units that have a front
panel display that is capable of displaying the signal quality, selecting
this checkbox will enable the signal quality display.
Deny Inter-Client Traffic on this Interface-- Select this checkbox if
you wish to prevent wireless stations from sending packets to each other
directly. Usually, the AP will repeat station-to-station traffic and will not
send it to the bridge and firewall filters. This is because bridging routines
historically work between physical interfaces only.
An Ethernet packet sent between two Ethernet hosts on the same
Ethernet subnet will automatically be seen by the destination host. With
wireless, the packet must be repeated by the AP. This turns off the AP's
packet repeating code.
Secure Data Mode Advanced Setup
Clicking the Advanced Button on the 802.11 Setup screen displays the
802.11 advanced Setup screen, which allows you to configure more
options related to the setup of your 802.11 network device.
The appearance of the 802.11 Setup screen varies depending on which
options are set on the 802.11 Setup screen. The 802.11 Advanced Setup
screen for a Secure Data Mode Base Station is shown below.
Figure 4-52
Advanced setup dialog box
[802.11a]
WLAN Cable Access Point 6220 CSU NTPM99CA Rel 2.0 Issue 5 Dec 2005
119