Nortel 6220 User Manual page 62

Figure 4-4
Test Network Configuration (Radio Connection)
3. Prepare a Laptop computer and a client unit to test and configure the
CSU at the installation location.
4. Connect Laptop PC to CSU Ethernet port with a straight-forward
cable to setup.
5. Launch the Configurator by either double clicking the WLAN Cable
AP Configurator icon on your desktop or by opening the file
config.exe from the directory "C:\Program Files\Nortel\WLAN
Cable AP Configurator" where software is installed at.
6. Run the Configurator and the IP Address for your APU (and the IP
addresses for any other devices in your network) as appears in the
Configurator window below.
Note: In factory default, APU and CSU have a default IP address as
"198.17.74.254" regardless of the software modes (APU, CSU mode),
which means that APU and CSU are ready to get it's IP address from a
remote DHCP Server. Therefore, when you launch AP configurator at
PC with CSU turned on at first, you can find the default IP address of the
CSU showing the green exclamation point "198.17.74.254" in the List of
Scanned Devices window. In case that DHCP service is available in the
cable network, you can find a new local IP address assigned to the unit
from DHCP server in the list box except the default IP address.
WLAN Cable Access Point 6220 CSU NTPM99CA Rel 2.0 Issue 5 Dec 2005
63