Troubleshooting Guide - Smooth Fitness SMT9.2AB Owner's Manual

Troubleshooting Guide

Treadmill will not start
1 Is the Safety Key inserted into the treadmill Console?
2 Make sure the power cord is plugged into a surge protector, the surge protector is
plugged into a properly grounded outlet, and the surge protector is turned on. (Refer to
"Power Requirements" on page 8)
3 Check the circuit breaker located on the front of the treadmill. If the switch protrudes, it
has tripped. Wait five minutes and then press the switch back in.
4 Check the house electrical breaker box and the circuit breaker for the room where the
treadmill is located. If it has tripped, reset or have an electrician replace the breaker in
home.
5 Have an electrician check for inadequate voltage at the outlet.
Treadmill loses power during use.
1 Check the circuit breaker located on the front of the treadmill. If the switch protrudes, it
has tripped. Wait five minutes and then press the switch back in.
2 Check the house electrical breaker box and the circuit breaker for the room where the
treadmill is located. If it has tripped, reset or have an electrician replace the breaker in
home.
3 If the treadmill still will not operate, please call Technical Service at (888) 340-0482.
Treadmill walking belt slows during use
1 Check to make sure the treadmill is securely plugged into an UL-listed surge protector,
rated at 15 amps, with a 14-gauge cord of five feet or less and the surge protector is
securely plugged into the outlet.
2 If treadmill still will not operate, please call Technical Service at (888) 340-0482.
Treadmill walking belt slips or is not centered on rear roller
1 Refer to "Belt Adjustment and Tension" section on page 15.
2 Need help? Call Technical Service at (888) 340-0482.
Treadmill Error Messages
Your treadmill is equipped with a software package that enables error messages to be dis-
played when there is a problem. To avoid possible damage to the treadmill and the
possibility of injury, do not operate the treadmill until the problem is corrected.
.
.
17
.
.