Assembly Instructions - Smooth Fitness SMT9.2AB Owner's Manual

Assembly Instructions

Minor Assembly Required!
The Smooth 9.2P and AB treadmill is shipped in two pieces: the console upright assembly, and the
base assembly. After opening the box, remove any packing materials from the treadmill. Do not
throw away any packing materials until the unit is working properly. The treadmill box contains a
package that includes the Owners Manual, a RED SAFETY KEY, and a belt adjustment tool. The
treadmill will not operate without the Red Safety Key.
The console upright assembly is attached to the base assembly. Place the unit on a clean, level
surface near an electrical outlet (extension cords are not recommended).
See Figure 1
1. Raise the console into an upright position. Loosely install both 3/4" buttonhead screws on
each side of the upright. Install and tighten each 3 1/2" x 5/16" bolt (2) with washers from the
bottom of the base frame through the upright lock (diag. 1).
2. Now tighten the buttonhead screws securely from step 1.
3. Install motor hood cover using 5/8" phillips head screws (8 screws).
Be sure the treadmill is level to the floor. The rear feet can be adjusted to level the treadmill.
Assembly is now complete!
Figure 1
8