Troubleshooting Guide; Trouble Shooting Your Treadmill - Smooth Fitness smt-935bt User Manual

9.35 TREADMILL
TROUBLESHOOTING
TROUBLE SHOOTING GUIDE:
SYMPTOM
Show E0 The Safety key is not in place
Show E1 Speed signal error
Show E2 Motor or motor drive system error
Show E3 Over speed error

TROUBLE SHOOTING YOUR TREADMILL:

If you experience a problem, please refer to the trouble shooting guide listed below:
PROBLEM: The console does not light up.
SOLUTION: Verify that the power cord is plugged in properly to the outlet, and the
treadmill power switch is turned on.
PROBLEM: The treadmill circuit breaker trips during a workout.
SOLUTION: Verify that the treadmill is plugged into a dedicated 15 amp circuit with the correct outlet.
*Note: Do not use an extension cord.
PROBLEM: The treadmill shuts off when elevating.
SOLUTION: Verify that there is enough slack in the power cord to reach to the wall
outlet during elevation.
PROBLEM: The running belt does not stay centred during a workout.
SOLUTION: Verify that the treadmill is on a level surface. Verify that the belt is
properly tightened. (Refer to Belt Adjustment)
PROBLEM: The treadmill makes a clicking noise towards the front of the machine
while walking or running on it.
SOLUTION: Verify that the treadmill is on a level surface.
CAUSE SOLUTION
Place the safety key onto the operation
position
Check Speed sensor and 10-pin cable or
contact your retailer
Check the 10-pin cable or contact your
retailer
Adjust the speed sensor or contact your
retailer