Section 2 Instrument Use; Starting-Up - Hach DRB 200 Instrument Manual

Section 2

2.1 Starting-up

DANGER
The ventilation slits
in the lid must not be
covered, or
overheating may
occur.
Initializing
V X.X
Figure 4 Back View of the DRB 200 Digital Reactor Block
1. Power Switch
2.1.1 Setting the Language
Instrument Use
1. Place the instrument on a stable, level, heat-resistant
surface.
2. Plug in the power cord into a power socket (100–230 V
+5%/–15%, 50/60 Hz).
3. Switch on the instrument by switching the power switch
(Figure 4).
4. After initialization, the instrument will beep once, indicating
that it is ready for operation. The display always shows the
most recent setting of the temperature programs after
initialization.
2. Power Plug
The default factory setting is English. To change the default
setting:
1. Hold down the left key while switching on the instrument.
15
3. Nameplate