Low-Paper Sensor Removal - Toshiba 1NR Hardware Service Manual

3. Release (but do not remove) the left lift spring to allow the low-paper sensor to
A
B
Figure 27. Low-paper sensor removal
4. Tilt the low-paper sensor off its center post and lift it out of its slot.
To replace the low-paper sensor, complete the following steps:
1. Insert the bottom of the sensor into the slot on the printer unit and align the hole
2. Rotate the top of the sensor toward the unit until it clicks into place.
3. Route the cable through the four cable guides along the left side of the unit and
4. Connect the cable to the logic card; then install the logic card (see "Removing
5. Rotate the sensor clockwise until it stops to the table mount position.
6. Push the leg of the left lift spring back into place. Ensure that the hook on the
7. Replace the main cover and top covers (see "Removing the main cover" on
8. Ensure the low-paper sensor is in the correct mounting position.
move to the full counterclockwise position (as shown by C ).
Note: You must pull the sensor slightly toward you to get it to lift over the
wall-mount detente and move to the full counterclockwise position.
C
in the sensor with the pivot point.
pass the cable under the paper basket and to the right side of the printer unit.
Note: It might be easier to route the cable through the guides if you press one
wire at time of the low-paper sensor cable into the cable guides.
the logic card" on page 60 for information on installing the logic card).
end of the spring is inserted into the slot completely.
page 55 and "Removing the main cover" on page 55 for more information).
Removing and replacing FRUs
Chapter 5. Removing and replacing FRUs
67