Removing The Low-Paper Sensor - Toshiba 1NR Hardware Service Manual

Removing and replacing FRUs
Figure 26. Place Holder for Future Artwork
2. Install the four lower rollers:
3. Install the upper roller:
4. If necessary, replace the paper door assembly and lift springs (see "Removing

Removing the low-paper sensor

Follow these steps to remove the low-paper sensor:
1. Follow the steps in "Removing the logic card" on page 60 to access the
2. Remove the low-paper sensor cable from its cable guides on the left side of the
66
SureMark Hardware Service
a. Orient the roller with the large gap to the left.
b. Insert the opposite end of the roller into the mounting hole on the right side
of the printer unit frame.
c. Bend the left side of the roller slightly and insert it into the mounting hole.
d. Repeat steps 2a through 2c for each of the remaining rollers.
a. Align one end of the roller with a mounting hole.
b. Press the two sides of the frame apart and insert the opposite end of the
roller into the mounting hole.
the cutter motor and paper door assembly" on page 62 for information).
low-paper sensor cable connector.
Note: Do not disconnect any cables other than the low-paper sensor cable
(three-wire connector) from the logic card.
unit and slide it out from under the paper basket.
A
B