Wiring The Antenna Unit Data Cable; Wiring The Antenna Unit Power Cable - KVH Industries TracVision 4 Technical Manual

TracVision 4 Installation and Technical Manual
Data Cable Wiring Arrangement
2-8

2.3.1 Wiring the Antenna Unit Data Cable

Find the TracVision 4 data cable where it comes through the
panel cutout made earlier. Wire the data cable to the switchplate
connectors as indicated in Figure 2-9. The connector board is
etched with the same wire color identification to make the wiring
process easier.
A comprehensive wiring diagram for the TracVision 4 system has
Figure 2-9
been provided in Appendix D.

2.3.2 Wiring the Antenna Unit Power Cable

Find the TracVision 4 power cable where it comes through the
panel cutout made earlier. Wire the antenna unit power cable to
the switchplate connectors as indicated in Figure 2-10 (on next
page). After wiring the power cable, connect the power indicator
lamp, also as noted in Figure 2-10. After both the power cable
and lamp are properly wired, carefully insert the lamp into its
socket immediately below the switchplate connectors.
BLU/WHT Not Used
WHT/BLU Not Used
BRN/WHT PC GND
WHT/BRN PC TXD
Data Cable
ORG/WHT PC RXD
to Antenna
WHT/ORG RF GND
GRY/WHT RF TXD
WHT/GRY RF RXD
GRN/WHT Not Used
WHT/GRN Not Used