KVH Industries TracVision 4 Technical Manual page 70

TracVision 4 Installation and Technical Manual
G-6
Set RF Tracking Parameters
Function: sets RF tracking parameter
Command: @SATCONFIG,X,N,F,S,C,ID,P,B,D<cr>
Response: Echoes the input data
Where: @SATCONFIG = directs data to the RF Board
X = satellite location A or B
N = satellite table # (98 & 99 are slots for user-
F = frequency in MHz (either 00000 or a range
S = the satellite transponder symbol rate in
C = the FEC code (e.g., 12, 23, 34, 56, 67, 78)
ID = the satellite network ID in hexidecimal format
P = the LNB polarization (v = vertical, h =
B = the LNB down conversion frequency (l = low,
D = decoding type (0 = test, 1 = DSS-A, 2 =
ID Match/Decoded Network ID
Function: report ID match and decoded network ID
Command: @CHECKID
Response: Y,0X####
N,0X####
Y,NoID
N,NoID
Where: Y = yes
N = no
0X#### = network ID
NoID = satellite unidentified
configured satellites)
from 10700 - 12700)
Mbit/sec (01000 - 29999)
(0x####)
horizontal)
h = high, u = USA)
DSS-B, 3 = DVB)