Table of Contents
Advertisement
5.3 Operating modes
This appliance is programmed to provide 3 operating settings, which can be modified by pressing PT2.
5.4 First use
When using for the first time, or after a power failure, the oven's left hand-display, DSP1, will show a
flashing
symbol. To start any cooking operation, the current time must be set.
5.4.1 Setting the current time
Adjusting the current time:
turn PT1 to the right and left to increase or decrease the hours respectively. (If the knob is held in one
•
direction the time changes faster).
•
when PT1 is released, after a few seconds the display will stabilize and only the two dots that
separate the hours from the minutes will flash, indicating it is working properly. (The display will also
show the symbol
Note: It might become necessary to change the current time, for example at daylight savings time.
Starting from the stand-by setting, (see paragraph "5.3 Operating modes"):
•
hold down PT1 for a few seconds until the symbol
•
repeat the operations described in paragraph "5.4.1 Setting the current time".
5.5 Selecting a function
In the ON status only, a cooking function can be selected by simply turning PT2 to the right or left. The
selected function will change color to red on the display. After the selection, the preset cooking
temperature will be displayed on DSP2.
5.5.1 Cooking at a preset temperature
After selecting the desired function, the oven will start the cooking procedure at the preset temperature
and the symbol
will come on. Cooking itself is preceded by a preheating stage, which allows the
oven to heat to the cooking temperature more quickly. The
this stage is in progress. When the preheating stage is over, the
will sound to indicate that the food can be placed inside the oven.
Instructions for the User
).
STAND-BY setting: with DSP1 on and showing the
current time (activated as soon as the current time has
been confirmed).
ON setting: from the stand-by setting, press PT2 once.
All the displays and knobs light up.
OFF setting: from the ON position, keep PT2 pressed
until it turns off. Only the
on.
stops flashing.
symbol flashes on DSP2 to indicate that
symbol will remain on and a buzzer
symbol on DSP1 remains
13
Advertisement
Table of Contents
