Table of Contents
Advertisement
8.3 Programming
Cooking duration: the cooking duration can be set. Before it can be set, the thermostat must be turned to
the cooking temperature required and the function selector knob to any setting. To set the cooking
duration, proceed as follows:
-
Press the
-
Keep the
minder. Each time a key is pressed, 1 outside segment, representing 1 minute of
cooking time, will light up or go out. Keep both value modification keys pressed to
change the numbers displayed more quickly.
-
The maximum programmed cooking duration is 11 hours and 59 minutes.
-
After one complete revolution, the numbers will start to flash in sequence,
indicating that the time has exceeded 60 minutes. For example, figure 2 shows a
cooking duration of 2 hours and 40 minutes.
-
A few seconds after the last key is pressed, the programmed cooking operation
will start; when it finishes, the buzzer will sound.
-
At the end of the cooking time the timer will switch the oven heating elements off, the beeps will start
to sound and the numbers on the display will flash.
-
At the end of the time set, 10 beeps will sound in sequence; they are repeated 3 times at one minute
intervals. This sequence can be stopped at any time by pressing
-
The
key can be pressed while the buzzer is active to vary the volume.
-
The duration can also be reset by resetting the program selected: pressing the central
few seconds will delete the duration set and the oven will have to be switched off in manual mode.
At the end of programmed cooking, manual operation of the oven has to be restored by holding
down the
key for a few seconds.
Starting cooking: as well as setting a cooking duration, the cooking start time can also be set (with a
maximum delay of 12 hours from the current time). To set the cooking start/end time, proceed as follows:
-
Set the cooking duration as described in the previous point.
-
Press the
keys to set the cooking start time.
-
A few seconds after the last key is pressed, the cooking start time will appear on the display.
-
At the start of a programmed cooking operation, the dot between 12 and 1 will also illuminate,
indicating that this is a programmed cooking procedure.
-
To view the current time at any moment, press the
will return to the display.
-
At the end of the cooking time the timer will switch the oven heating elements off, the beeps will start
to sound and the numbers on the dial will flash.
-
To reset the whole program set, keep the central
already started, the oven will have to be switched off by hand.
At the end of programmed cooking, manual operation of the oven has to be restored by holding
down the
programming procedures just described, the thermostat and function selector knob must be
correctly set on the temperature and function required.
8.4 "DEMO" Function
Models with analogue/digital programmer feature a "DEMO" function which deactivates the heating
elements while leaving the other functions unchanged. To activate it, simply press the
keys for a few seconds. A confirmation beep will inform the user that the function is active.
Once the display shows the current time with the demo function activated, the number 6 will flash. To
deactivate it, simply repeat the same procedure.
40
Instructions for the User
key key and the display will light up as shown in figure 1.
key pressed and at the same time use
key again and hold it down. The current time appears on the display: use the
key for a few seconds. Caution: for the oven to start cooking operations after the
or
keys to set the minute
or
.
key. After a few seconds, the cooking start time
key pressed for a few seconds: if cooking has
1)
2)
key for a
and
,
, and
Hide quick links:
Advertisement
Table of Contents
