Programming The Automatic Cleaning Cycle - Smeg SUK61MPX5 Instruction Manual

Instructions for the user

12.9 Programming the automatic cleaning cycle

Turn the function selector to the symbol to start the pyrolysis cycle. After the orange light of the
thermostat has lit up and a few minutes have elapsed, the red «door-block» light also comes on to
indicate that the door of the appliance has been blocked owing to the high temperature inside the oven.
When the function selector moves to the display will show the symbol: this means that the
pyrolysis cycle will start immediately and will last one and a half hours. It is possible to prolong the
duration of the pyrolysis up to a maximum of 3 hours. To do so, after the cycle has started press the
key and within a few seconds key in the variation of value or . A few seconds after the last keying,
the display will show the letter P followed by the duration of the pyrolysis which has just been
programmed, and A will stop flashing.
After the pyrolysis has started and after having made any changes to the duration as described above, it
is also possible to programme the finishing time of the cleaning cycle.
Press the key. On the display, A will begin to flash and the total of the current time and the duration of
the pyrolysis cycle will be displayed. (Example: Current time: 12.10 - Programmed duration: 2.00 - Time
shown: 14.10). Now use the keys to change the or values to programme the time of the end of the
cleaning cycle. A few seconds after the last keying, the display will show the current time and the orange
light will go out and then come back on at the pre-selected time.
Note: do not leave anything in the oven during the pyrolysis cycle. Keep children away and take care
above all when the start of the cycle is postponed.
Under no circumstances should one use the hob during the pyrolysis cycle.
18