Step 1 Determine Location For Operator - Chamberlain Elite CSW200501UL Installation Manual

To AVOID damaging gas, power or other underground utility lines,
l
contact underground utility locating companies BEFORE digging more
than 18 inches (46 cm) deep.

Step 1 Determine Location for Operator

DO NOT run the operator until instructed.
The illustration below shows the recommended dimensions for a standard installation. If these dimensions are not applicable for your installation refer to
the chart on the following page for alternate dimensions.
Standard Installation
Refer to the illustration to determine the measurements and location of the concrete pad.
NOTE: There should only be a maximum of 4" (10.2 cm) from the center of the hinge to the edge of the post or column. If the distance is greater than 4"
(10.2 cm) entrapment protection for this area is required.
INSTALLATION
DO NOT touch the heater when switch is on, heater may be hot.
l
11