Installing Antenna; Figure 45 Rf Jumper Installation Position - Zte ZXMBW E9230 User Manual

F 45 RF J
IGURE
Steps 1. Connect the DIN connector (male) of the RF jumper to the DIN
connector (female) of main feeder.
2. Connect the N connector (male) of the RF jumper to the RF
antenna port (port 0/1) of ZXMBW E9230 cabinet.
3. Perform waterproof processing on the connectors, as shown in
Performing Outdoor-connector Waterproof
E
ND OF STEPS

Installing Antenna

Context
Technical parameters involved in antenna installation:
1. Antenna height: Determined by the network plan.
2. Antenna azimuth: Determined by the network plan.
3. Antenna pitch angle: Determined by the network plan, usually
adjustable between 0° to 10°.
4. Antenna directional angle: Determined by the antenna az-
imuth. The directional angles of the two antennas of one sector
must be the same.
The antenna installation position must be in accordance with
project design. If the installation position needs any modification,
the project supervisor must negotiate with operator's represen-
tative.
The antenna installation position needs to take care fore lightning
protection as shown in
I
UMPER NSTALLATION
Figure
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 Equipment Installation
P
OSITION
Processing.
46.
51