Inspections - Genie S-60 TRAX Operator's Manual

Operator's Manual
Controls
19 Drive enable switch
To drive when the drive enable light is flashing,
hold the drive enable switch to either side and
slowly move the drive control handle off center.
Be aware that the machine may move in the
opposite direction that the drive and steer
controls are moved.
20 Drive speed select switch
Machine on incline symbol: Low range
operation for inclines.
Machine on level surface symbol: High range
operation for maximum drive speed.
21 Steer mode select switch (if equipped)
Move the steer mode select switch to the left to
select square-end steer. Move the steer mode
select switch to the right to select coordinated
steer.
22 Emergency power switch
Use emergency power if the primary power
source fails.
Simultaneously hold the emergency power
switch up or down and activate the desired
function.
23 Engine RPM select switch
Move the engine RPM select switch to the
turtle position to activate low idle. Move the
engine RPM speed select switch to the rabbit
position to activate high idle.

Inspections

28
® ®
S -60 XC™ • S -65 XC™ • S
24 Engine start switch
Move the engine start switch to either side to
start the engine.
25 Gasoline/LPG models: Fuel select switch
Move the fuel select switch to the gasoline
position to select gasoline. Move the fuel
select switch to the LPG position to select
LPG.
26 Thumb rocker switch for boom extend/retract
function
Push the top of the rocker
switch and boom will retract.
Push the bottom of the rocker
switch and the boom will
extend.
27 Dual axis proportional control handle for boom
up/down and turntable rotate left/right
functions
Move the control handle up and
the boom will raise. Move the
control handle down and the
boom will lower.
Move the control handle to the
right and the turntable will rotate
to the right. Move the control
handle to the left and the
turntable will rotate to the left.
® ®
-60 TRAX™ • S -65 TRAX™
First Edition • Second Printing
Part No. 1286582GT