Fiber Optic Ethernet Ports; Sfp Transceivers - Siemens RUGGEDCOM RS900GP Installation Manual

RUGGEDCOM RS900GP
Installation Guide
Section 4.3

Fiber Optic Ethernet Ports

Optional 100Base-FX, 1000Base-SX and 1000Base-LX fiber optic Ethernet ports are available for ports 9 and 10
with either LC (Lucent Connector) and SC (Standard or Subscriber Connector) connectors. Make sure the Transmit
(Tx) and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
Available Ports
1
Figure 17: SC Connector
1. Tx Connector 2. Rx Connector
LEDs
Each port features an LED that indicates its link/activity state.
Figure 19: LED for Fiber Optic Ethernet Ports
1. Link/Activity LED
Specifications
For further specifications, refer to
Section 4.4

SFP Transceivers

The RUGGEDCOM RS900GP supports up to two Small Form-Factor Pluggable (SFP) transceiver sockets, which are
compatible with a wide array of SFP transceivers available from Siemens.
LEDs
Each socket features an LED that indicates its link state.
Fiber Optic Ethernet Ports
1 1
Section 5.5, "Fiber Optic Ethernet Port
2
Figure 18: LC Connector
1. Tx Connector 2. Rx Connector
State
Green (Solid)
Green (Blinking)
Off
Communication Ports
1
Description
Link established
Link activity
No link detected
Specifications".
Chapter 4
2
21