Required Tools And Materials; Decommissioning And Disposal - Siemens RUGGEDCOM RS900GP Installation Manual

RUGGEDCOM RS900GP
Installation Guide
ALARM LED
Failsafe Alarm Relay
Power Supply Terminal Block
Section 1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RS900GP:
DC power cord (16 AWG)
CAT-5 Ethernet cables
#2 Phillips Flathead screwdriver
Phillips screwdriver
4 x M3.5 (#6-32) screws
Section 1.4

Decommissioning and Disposal

Proper decomissioning and disposal of this device is important to prevent malicious users from obtaining
proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of service, either permanently or
for maintenance by a third-party, make sure it has been fully decommissioned.
For more information, refer to the associated User Guide.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related accessories, contact a facility
certified to dispose of waste electrical and electronic equipment. Recycling and disposal must be done in
accordance with local regulations.
Required Tools and Materials
Illuminates when an alarm condition exists.
Latches to default state when a power disruption or other alarm condition occurs. For more
information, refer to:
• Section 2.6, "Connecting the Failsafe Alarm Relay"
• Section 5.3, "Failsafe Alarm Relay Specifications"
A pluggable terminal block. For more information, refer to:
• Section 2.7, "Connecting Power"
• Section 5.1, "Power Supply Specifications"
Tools/Materials
For connecting power to the device.
For connecting the device to the network.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Introduction
Purpose
Chapter 1
3