Print Data; Print Data Continuously; Network Setup - Hach DR 6000 User Manual

5.2.7.2

Print data

5.2.7.3

Print data continuously

5.2.7.4

Network setup

7. Press Network Printer to define the network printer.
Automatic: All available printers in the local network are
listed.
Select the required printer and press OK to confirm.
Fixed: Enter the IP address of the required printer and press
OK to confirm.
8. Press OK to confirm the entry.
Note: Press OK again to return to the "Instrument Setup" menu.
1. Press Recall Data from the Main Menu.
2. Select the data source, where the data to be printed are
stored.
A list is displayed. Data can be filtered. Refer to
section 5.3.1.2, page 45
3. Press the Printer icon to send the data (table, curve)
immediately to the printer.
4. Highlight Single point, Filtered data or All data and press
OK to confirm.
Send data... appears on the display until the data is
printed.
If you would like to automatically print out all measured values
immediately after measurement, the use of a continuous form
printer is recommended, for example the 4" paper thermal printer
refer to Section 9, Page
1. Connect the thermal printer to a USB type A port.
2. Press PC & Printer in the "Instrument Setup" menu.
A list with information about the connections opens.
3. Highlight Printer.
4. Press Setup to display the Printer Setup screen.
5. Activate Auto Send: On to send all measurement data
automatically to the thermal printer. Also activate in the data
log setup the Auto Send function. Refer to
The DR 6000 supports communication over local networks. For
the setup of an Ethernet communication in networks, a special
configuration is required. The manufacturer recommends support
from a network administrator. Only use a shielded cable
(e.g. STP, FTP, S/FTP) with a maximum length of 20 m for the
Ethernet port. This section describes the setting options for the
photometer in relation to network communication.
Standard programs
for more information.
143.
section 5.3.1.1.
39