ZyXEL Communications XMG3512-B10A User Manual page 93

Note: The XMG applies the security settings of the
you want to use the WPS feature, make sure you have set the security mode of
or
WPA2- PSK No Se c urity
Click
Ne two rk Se tting > Wire le ss > WPS
activate the WPS function. Then you can configure the WPS settings in this screen.
Network Setting > Wireless > WPS
Fig ure 39
The following table describes the labels in this screen.
Table 24 Network Setting > Wireless > WPS
L ABEL DESC RIPT IO N
General
WPS Select Enable to activate WPS on this XMG.
Add a new device with WPS Method
Method 1 Use this section to set up a WPS wireless network using Push Button Configuration (PBC). Select
Ena b le
WPS Click this button to add another WPS-enabled wireless device (within wireless range of the
XMG) to your wireless network. This button may either be a physical button on the outside of
device, or a menu button similar to the
Note: You must press the other wireless device's WPS button within two minutes of
Method 2 Use this section to set up a WPS wireless network by entering the PIN of the client into the XMG.
Select
Register Enter the PIN of the device that you are setting up a WPS connection with and click
authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device's settings.
Note: You must also activate WPS on that device within two minutes to have it
Method 3 Use this section to set up a WPS wireless network by entering the PIN of the XMG into the client.
Select
Chapter 7 Wireless
.
. The following screen displays. Select
and click to activate WPS method 1 on the XMG.
Apply
pressing this button.
and click to activate WPS method 2 on the XMG.
Ena b le Apply
present its PIN to the XMG.
and click to activate WPS method 3 on the XMG.
Ena b le Apply
XMG3512-B10A User's Guide
93
profile (see Section 7.2 on page
SSID1
Ena b le
button on this screen.
WPS
84). If
to
SSID1
and click to
Apply
to
Re g iste r